No Snmp Targetparams; Snmp V1-V2 Readonly - Siemens SCALANCE XC-200 Configuration Manual

Further notes
You delete the SNMP target parameters with the no snmp targetparams command.
You display settings of this function with the show snmp targetparam command.
You configure the user profile with the snmp user command.
You display the list of users with the show snmp user command.
7.5.2.17

no snmp targetparams

Description
With this command, you delete the SNMP target parameters.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp targetparams <ParamName>
The parameter has the following meaning:
Parameter
ParamName
Result
The SNMP target parameters are deleted.
Further notes
You change the SNMP target parameters with the snmp targetparams command.
You display settings of this function with the show targetparam command.
7.5.2.18

snmp v1-v2 readonly

Description
With this command, you block write access for SNMPv1 and SNMPv2 PDUs.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Name of the SNMP parameter
Network protocols
7.5 SNMP
Range of values / note
max. 32 characters
345