Dcp Server - Siemens SCALANCE XC-200 Configuration Manual

Network protocols
7.1 IPv4 protocol
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no telnet-server
Result
The Telnet server is disabled.
Further notes
You enable the Telnet server with the telnet-server command.
7.1.2.7

dcp server

Description
With this command, you configure the read and write permissions for the DCP server and
enable it.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
dcp server {read-only|read-write}
The parameters have the following meaning:
Parameter
read-only
read-write
276
Description
only reading is permitted on the DCP
server
reading and writing is permitted on the
DPC server
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
Default: read-write
Configuration Manual, 07/2017, C79000-G8976-C361-06