No Mac-Address-Table Static Multicast - Siemens SCALANCE XC-200 Configuration Manual

Load control
10.2 Static MAC filtering
Syntax
Call up the command with the following parameters:
mac-address-table static multicast <aa:aa:aa:aa:aa:aa>
The parameters have the following meaning:
Parameter
aa:aa:aa:aa:aa
:aa
interface
interface-type
interface-id
port-channel
forbidden-
ports
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The entry in the forwarding database is generated.
Further notes
With the show dot1d mac-address-table static multicast command, you display
the list of configured entries.
With the no mac-address-table static multicast command, you delete an entry.
10.2.2.2

no mac-address-table static multicast

Description
With this command, you delete a static multicast MAC address entry from the forwarding
database.
Requirement
You are in the Global configuration mode.
466
interface ([<interface-type> <interface-id>]
[<interface-type> <interface-id>]
[port-channel <1-8>]])
[forbidden-ports ([<interface-type> <interface-id>]
Description
MAC address of the interface
Keyword for a an interface description
Type of interface
Module no. and port no. of the interface
Specifies the name of a port channel
Keyword for the interface description of the
blocked ports
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
[<interface-type> <interface-id>]
[port-channel <1-8>]])
Configuration Manual, 07/2017, C79000-G8976-C361-06
Range of values / note
-
-
Specify a valid interface.
1-8
-