Switchport Mode - Siemens SCALANCE XC-200 Configuration Manual

cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport access vlan
Result
The setting is reset to the default value.
Further notes
You configure the setting with the switchport access vlan command.
You can display the status of this function and other information with the show vlan port
configcommand.
6.1.3.7

switchport mode

Description
With this command, you specify the operating mode for the switch port.
Requirement
● The interface is configured as a switch port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport mode { trunk | hybrid }
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Network structures
6.1 VLAN
183