Commands In The Global Configuration Mode; Monitor - Siemens SCALANCE XC-200 Configuration Manual

cli> or cli#
Syntax
Call up the command with the following parameters:
show monitor {session <session-id(1-1)>}
The parameters have the following meaning:
Parameter
session
session-id
Result
The settings for mirroring ports are displayed.
12.5.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
12.5.2.1

monitor

Description
With this command, you enable the port mirroring function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
monitor
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Keyword for a session whose settings
are displayed
Number of the session
Diagnostics
12.5 Port Mirroring
Range of values / note
-
1
589