Commands In The Global Configuration Mode; Loadsave - Siemens SCALANCE XC-200 Configuration Manual

Configuration
3.2 Load and Save
Parameter
ipv4
ipv4-address
port
tcp port
file
filename
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The file is saved on the TFTP server.
Further notes
With the "show loadsave files" command, you can display the file types.
3.2.5

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
3.2.5.1

loadsave

Description
With this command, you change to the LOADSAVE configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
94
Description
Keyword for an IPv4 address
Value for an IPv4 unicast address
Keyword for the port of the server via
which the TFTP connection runs
Number of the port
Keyword for a file name to be assigned -
Name of the file
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
Enter a valid IPv4 unicast address.
-
1 ... 65535
Default: 69
max. 100 characters
Configuration Manual, 07/2017, C79000-G8976-C361-06