Spanning-Tree Mst - Siemens SCALANCE XC-200 Configuration Manual

You can display the status of this function and other information with the following commands:
● show spanning-tree detail
● show spanning-tree active detail
● show spanning-tree interface
6.3.5.12

spanning-tree mst

Description
With this command, you configure the various properties of the Multiple Spanning Tree
function:
● With the cost option, you configure the port costs used to calculate the lowest-cost path.
● With the port-priority option, you configure the priority of the interface for negotiating
a Multiple Spanning Tree configuration.
● With the disable option, you disable the interface for the Multiple Spanning Tree function.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree mst<instance-id(1-64)>
The parameters have the following meaning:
Parameter
instance-id
cost
port-priority
disable
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
{cost(0-200000000)|port-priority (0-240)|disable}
Description
Number of the addressed instance
Costs of the port for calculating the low‐
est cost path.
Priority of the interface
Disables the interface for multiple span‐
ning tree
Network structures
6.3 Spanning Tree
Range of values / note
1 ... 64
0 ... 200000000
Default:
● 200000 for physical interfaces
● 199999 for port channels
0 ... 240 in steps of 16
Default: 128
Default: MST is disabled, RST is
enabled
251