Siemens SCALANCE XC-200 Configuration Manual page 244

Network structures
6.3 Spanning Tree
Parameter
link-type
portfast
port-priority
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no spanning-tree {cost|disable|link-type|portfast|port-priority}
The parameters have the following meaning:
Parameter
cost
disable
link-type
portfast
port-priority
Note
Configure multiple properties
With each call of the command, you can configure precisely one property.
If you want to configure several properties, call the command several times.
Result
The selected setting was reset to the default value.
Further notes
You configure the setting with the spanning-tree command (properties).
You display these settings and other information with the commands that start with show
spanning tree ....
244
Default value
● point-to-point
The connection is configured as full-duplex
● shared
in all other cases
disabled
128
Description
Keyword for the costs of the port for calculating the lowest-cost path.
Enables the interface for spanning tree.
Connection status of the following network segment
Disables the PortFast function.
Keyword for the priority of the interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06