Sntp Time Diff - Siemens SCALANCE XC-200 Configuration Manual

Requirement
● The SNTP client is activated.
● You are in the SNTP Configuration mode.
The command prompt is:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
sntp client addressing-mode{unicast|broadcast}
The parameters have the following meaning:
Parameter
unicast
broadcast
Result
The addressing mode of the SNTP client is configured.
Further notes
You display this setting and other information with the show sntp status command.
You display the settings for the unicast mode with the show sntp unicast-mode
status command.
You display the settings for the broadcast mode with the show sntp broadcast-mode
status command.
5.3.3.2

sntp time diff

Description
With this command, you configure the time difference of the system time relative to the UTC
time.
Requirement
● The SNTP server must have started up.
● You are in the SNTP Configuration mode.
The command prompt is:
cli(config-sntp)#
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
configures the SNTP client in unicast
mode
configures the SNTP client in broadcast
mode
System time
5.3 SNTP client
Range of values / note
Default: unicast enabled
Supports only IPv4 addresses
157