Configuring Igmp Snooping - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Parameter
Leave Timer (ms)
4. Enable GMRP on one or more switched Ethernet ports. For more information, refer to
"Configuring a Switched Ethernet
5. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6. Click Exit Transaction or continue making changes.
Section 5.25.3

Configuring IGMP Snooping

To configure IGMP snooping, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Navigate to switch » mcast-filtering » igmp-snooping. The IGMP Snooping form appears.
Figure 662: IGMP Snooping Form
1. IGMP Mode List
3. Configure the following parameter(s) as required:
Parameter
IGMP Mode
Configuring IGMP Snooping
Description
Default: 4000
The time in milliseconds to wait after issuing Leave or LeaveAll before removing
registered multicast groups. If Join messages for specific addresses are received before
this timer expires, the addresses will be kept registered.
Port".
1
2
3
4
2. IGMP Query Interval Box
Description
Synopsis: active, passive
Default: passive
Specifies the IGMP mode:
• PASSIVE : The switch passively snoops IGMP traffic and never sends IGMP queries.
3. Router Forwarding Check Box
Setup and Configuration
Section 3.18.2,
4. RSTP Flooding Check Box
Chapter 5
571