Show Ip Igmp Snooping Switch-Ip; Commands In The Global Configuration Mode; Ip Igmp Snooping Version - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.2 IGMP snooping
8.2.1.4

show ip igmp snooping switch-ip

Description
This command shows the IP address of the source for IGMP snooping.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ip igmp snooping switch-ip
Result
The IP address is displayed.
8.2.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
8.2.2.1

ip igmp snooping version

Description
This command specifies which version of IGMP the device will use. When shipped, the
device uses IGMPv3.
Note
There is no separate show command to display the version of IGMP used by the device.
This information is shown when you enter the
EXEC mode or in the Privileged EXEC mode.
394
or
cli#
command to change to this mode.
configure terminal
or
end exit
show ip igmp snooping
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command and are then in the
command in the User