Sbus<N>:Spi:trigger:type - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:SBUS<n>:SPI:TRIGger:TYPE
Command Syntax
:SBUS<n>:SPI:TRIGger:TYPE <value>
<value> ::= {MOSI | MISO}
The :SBUS<n>:SPI:TRIGger:TYPE command specifies whether the SPI
trigger will be on the MOSI data or the MISO data.
When triggering on MOSI data, the data value is specified by the
:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA and
:SBUS<n>:SPI:TRIGger:PATTern:MOSI:WIDTh commands.
When triggering on MISO data, the data value is specified by the
:SBUS<n>:SPI:TRIGger:PATTern:MISO:DATA and
:SBUS<n>:SPI:TRIGger:PATTern:MISO:WIDTh commands.
Query Syntax
:SBUS<n>:SPI:TRIGger:TYPE?
The :SBUS<n>:SPI:TRIGger:TYPE? query returns the current SPI trigger
type setting.
Return Format
<value><NL>
<value> ::= {MOSI | MISO}
See Also
•
•
•
•
•
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
"Introduction to :TRIGger Commands"
":SBUS<n>:SPI:SOURce:DATA"
":SBUS<n>:SPI:SOURce:MOSI"
":SBUS<n>:SPI:SOURce:MISO"
":SBUS<n>:SPI:TRIGger:PATTern:MISO:DATA"
":SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA"
":SBUS<n>:SPI:TRIGger:PATTern:MISO:WIDTh"
":SBUS<n>:SPI:TRIGger:PATTern:MOSI:WIDTh"
":TRIGger:MODE" on page 851
on page 843
on page 711
on page 714
on page 713
on page 715
on page 717
on page 716
on page 718
26
:SBUS<n> Commands
719