Marker:yunits - Agilent Technologies InfiniiVision 3000 Programmer's Manual

18
:MARKer Commands

:MARKer:YUNits

Command Syntax
:MARKer:YUNits <units>
<units> ::= {BASE | PERCent}
The :MARKer:YUNits command sets the Y cursors units:
• BASE — for making measurements in the units associated with the
• PERCent — for making ratio measurements. Use the
Changing Y units affects the input and output values of the
:MARKer:Y1Position, :MARKer:Y2Position, and :MARKer:YDELta
commands/queries.
Query Syntax
:MARKer:YUNits?
The :MARKer:YUNits? query returns the current Y cursors units.
Return Format
<units><NL>
<units> ::= {BASE | PERC}
See Also •
•
•
•
•
•
•
•
376
(see page 1088)
cursors source.
:MARKer:YUNits:USE command to set the current Y1 location as 0
percent and the current Y2 location as 100 percent.
"Introduction to :MARKer Commands"
":MARKer:YUNits:USE"
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MEASure:SOURce"
":MARKer:Y1Position"
":MARKer:Y2Position"
":MARKer:YDELta" on page 375
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 364
on page 377
on page 367
on page 369
on page 421
on page 373
on page 374