Sbus<N>:Can:source - Agilent Technologies InfiniiVision 3000 Programmer's Manual

26
:SBUS<n> Commands
:SBUS<n>:CAN:SOURce
Command Syntax
:SBUS<n>:CAN:SOURce <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital<d>} for the MSO models
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :SBUS<n>:CAN:SOURce command sets the source for the CAN signal.
Query Syntax
:SBUS<n>:CAN:SOURce?
The :SBUS<n>:CAN:SOURce? query returns the current source for the CAN
signal.
Return Format
<source><NL>
See Also
•
•
•
•
628
(see page 1088)
"Introduction to :TRIGger Commands"
":SBUS<n>:MODE" on page 599
":SBUS<n>:CAN:TRIGger"
":SBUS<n>:CAN:SIGNal:DEFinition"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 843
on page 629
on page 627