Wgen:period - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:WGEN:PERiod

Command Syntax
:WGEN:PERiod <period>
<period> ::= period in seconds in NR3 format
For all waveforms except Noise and DC, the :WGEN:PERiod command
specifies the period of the waveform.
You can also specify the period indirectly using the :WGEN:FREQuency
command.
Query Syntax
:WGEN:PERiod?
The :WGEN:PERiod? query returns the currently set waveform generator
period.
Return Format
<period><NL>
<period> ::= period in seconds in NR3 format
See Also •
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
"Introduction to :WGEN Commands"
":WGEN:FUNCtion" on page 970
":WGEN:FREQuency"
on page 961
on page 969
32
:WGEN Commands
979