Agilent Technologies InfiniiVision 3000 Programmer's Manual page 364

18
:MARKer Commands
Table 89 :MARKer Commands Summary (continued)
Command
:MARKer:XUNits <mode>
(see page 371)
:MARKer:XUNits:USE
(see page 372)
:MARKer:Y1Position
<position>[suffix]
(see page 373)
:MARKer:Y2Position
<position>[suffix]
(see page 374)
n/a
:MARKer:YUNits <mode>
(see page 376)
:MARKer:YUNits:USE
(see page 377)
Introduction to
The MARKer subsystem commands set and query the settings of X- axis
:MARKer
markers (X1 and X2 cursors) and the Y- axis markers (Y1 and Y2 cursors).
Commands
You can set and query the marker mode and source, the position of the X
and Y cursors, and query delta X and delta Y cursor values.
Reporting the Setup
Use :MARKer? to query setup information for the MARKer subsystem.
Return Format
The following is a sample response from the :MARKer? query. In this case,
the query was issued following a *RST and ":MARKer:MODE MANual"
command.
:MARK:X1Y1 CHAN1;X2Y2 CHAN1;MODE MAN
364
Query
:MARKer:XUNits? (see
page 371)
n/a
:MARKer:Y1Position?
(see page 373)
:MARKer:Y2Position?
(see page 374)
:MARKer:YDELta? (see
page 375)
:MARKer:YUNits? (see
page 376)
n/a
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
Options and Query Returns
<units> ::= {SEConds | HERTz |
DEGRees | PERCent}
n/a
<position> ::= Y1 cursor position
value in NR3 format
[suffix] ::= {V | mV | dB}
<return_value> ::= Y1 cursor
position value in NR3 format
<position> ::= Y2 cursor position
value in NR3 format
[suffix] ::= {V | mV | dB}
<return_value> ::= Y2 cursor
position value in NR3 format
<return_value> ::= Y cursors
delta value in NR3 format
<units> ::= {BASE | PERCent}
n/a