Trigger:delay:trigger:slope - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:TRIGger:DELay:TRIGger:SLOPe

Command Syntax
:TRIGger:DELay:TRIGger:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:DELay:TRIGger:SLOPe command specifies rising (POSitive) or
falling (NEGative) for the trigger edge in the Edge Then Edge triggger.
Query Syntax
:TRIGger:DELay:TRIGger:SLOPe?
The :TRIGger:DELay:TRIGger:SLOPe? query returns the current trigger edge
slope setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
"Introduction to :TRIGger Commands"
":TRIGger:DELay:TRIGger:SOURce"
":TRIGger:DELay:TDELay:TIME"
":TRIGger:DELay:TRIGger:COUNt"
on page 843
on page 860
on page 857
on page 858
30
:TRIGger Commands
859