Agilent Technologies InfiniiVision 3000 X Series Quick Demo Manual

Quick Demo Guide
Infi niiVision 3000 X-Series Oscilloscope
Using the "Auto Demo" mode
Use the scope's "Auto Demo" mode to quickly demonstrate the following key features
and capabilities of the oscilloscope in two easy steps without requiring an external
demo board:
Using the "Training Signals" mode for advanced demonstrations
Easy CAN serial bus decode/trigger using
the built-in "Training Signals"
1. Connect Channel-1 probe between the Demo1 test lug and
ground lug.
2. Connect Channel-2 probe between the Demo2 test lug and
ground lug.
3. Press [Default Setup] front panel key.
4. Press [Help] front panel key.
5. Press Training Signals softkey; then select the CAN
signal from the softkey menu list using the Entry knob.
6. Press Auto Setup softkey.
With hardware-based decoding, this scope quickly detects
the occurrence of infrequent CAN error frames. Note that it
is also very easy to demonstrate other serial bus protocols.
Simply select the desired Serial bus training signal, then
press the Auto Setup softkey
Search and navigation on CAN errors
7. Press [Serial] front panel key; then, press Lister softkey.
8. Press Display softkey; then select Serial 1 (CAN).
9. Set timebase to 200.0 ms/div using Horizontal scale knob.
10. Press [Run/Stop] to stop acquisitions.
11. Press [Search] front panel key; then select Serial 1 (CAN)
from the softkey menu list using Entry knob.
12. Press Search for softkey; then select All Errors.
The white triangles at the top of the waveform area indicate
the location of each "found" CAN Error Frame . Let's now
navigate to each CAN Error Frame and take a closer look
at each one.
13. Press the [◄] and [►] front panel navigation buttons to
automatically navigate to each CAN Error Frame.
Auto Demo shows
• Fast waveform update rate
• Mixed signal oscilloscope
• Serial bus decode and trigger
• Segmented memory acquisition
• Mask testing
• WaveGen function generator
Capturing 500 consecutive CAN frames with
ID = 07F using segmented memory
14. Press Horizontal position knob to set offset to 0 sec.
15. Set timebase to 100.0 μs/div using Horizontal scale knob.
16. Press [Run/Stop] front panel key.
17. Press [Acquire] front panel key.
18. Press Segmented softkey; then select # of Segments =
500 using Entry knob.
19. Press Segmented softkey to begin acquisition.
20. Press [Serial] front panel key; then press Lister softkey.
21. Press Scroll Lister softkey; then use Entry knob to review
all 500 captured frames in the list.
Segmented memory optimizes oscilloscope acquisition
memory to capture only those events that satisfy the
scope's trigger condition.