Power:switch:ireference - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:POWer:SWITch:IREFerence

Command Syntax
:POWer:SWITch:IREFerence <percent>
<percent> ::= percent in NR1 format
The :POWer:SWITch:IREFerence command to specify the current switching
level for the start of switching edges. The value is in percentage of the
maximum switch current.
You can adjust this value to ignore noise floors or null offset that is
difficult to eliminate in current probes.
This value specifies the threshold that is used to determine the switching
edges.
Query Syntax
:POWer:SWITch:IREFerence?
The :POWer:SWITch:IREFerence query returns the current switching level
percent value.
Return Format
<percent><NL>
<percent> ::= percent in NR1 format
See Also •
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
":POWer:SWITch:APPLy"
":POWer:SWITch:CONDuction"
":POWer:SWITch:RDS"
":POWer:SWITch:VCE"
":POWer:SWITch:VREFerence"
on page 553
on page 554
on page 556
on page 557
on page 558
23
:POWer Commands
555