Sbus<N>:Spi:clock:slope - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:SBUS<n>:SPI:CLOCk:SLOPe
Command Syntax
:SBUS<n>:SPI:CLOCk:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :SBUS<n>:SPI:CLOCk:SLOPe command specifies the rising edge
(POSitive) or falling edge (NEGative) of the SPI clock source that will
clock in the data.
Query Syntax
:SBUS<n>:SPI:CLOCk:SLOPe?
The :SBUS<n>:SPI:CLOCk:SLOPe? query returns the current SPI clock
source slope.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
"Introduction to :TRIGger Commands"
":SBUS<n>:SPI:CLOCk:TIMeout"
":SBUS<n>:SPI:SOURce:CLOCk"
:SBUS<n> Commands
on page 843
on page 708
on page 710
26
707