Mtest:{Start | Stop} - Agilent Technologies InfiniiVision 3000 Programmer's Manual

34
Obsolete and Discontinued Commands

:MTESt:{STARt | STOP}

(see page 1088)
Command Syntax
:MTESt:{STARt | STOP}
The :MTESt:{STARt | STOP} command starts or stops the acquisition
system.
The :MTESt:STARt and :MTESt:STOP commands are obsolete and are provided for
N O T E
backward compatibility to previous oscilloscopes. Use the :RUN command (see page 211)
and :STOP command (see page 215) instead.
See Also • "Introduction to :MTESt Commands" on page 469
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 1037