Sbus<N>:M1553:Autosetup - Agilent Technologies InfiniiVision 3000 Programmer's Manual

26
:SBUS<n> Commands
:SBUS<n>:M1553:AUTosetup
Command Syntax
:SBUS<n>:M1553:TRIGger:AUTosetup
The :SBUS<n>:M1553:AUTosetup command automatically sets these options
for decoding and triggering on MIL- STD- 1553 signals:
• High/Low Trigger Thresholds: to a voltage value equal to ±1/3 division
• Noise Reject: Off.
• Probe Attenuation: 10.0.
• Serial Decode: On.
• Trigger: the specified serial bus (n of SBUS<n>).
See Also
•
•
•
698
(see page 1088)
based on the source channel's current V/div setting.
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 851
":SBUS<n>:M1553:SOURce"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 843
on page 700