All Oscilloscope Commands Are Sequential - Agilent Technologies InfiniiVision 3000 Programmer's Manual

38
More About Oscilloscope Commands

All Oscilloscope Commands Are Sequential

IEEE 488.2 makes the distinction between sequential and overlapped
commands:
• Sequential commands finish their task before the execution of the next
• Overlapped commands run concurrently. Commands following an
All of the oscilloscope commands are sequential.
1096
command starts.
overlapped command may be started before the overlapped command is
completed.
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide