Agilent Technologies InfiniiVision 3000 Programmer's Manual page 595

Control the modes and parameters for each serial bus decode/trigger type.
See:
• "Introduction to :SBUS<n> Commands"
• "General :SBUS<n> Commands"
• ":SBUS<n>:A429 Commands"
• ":SBUS<n>:CAN Commands"
• ":SBUS<n>:FLEXray Commands"
• ":SBUS<n>:I2S Commands"
• ":SBUS<n>:IIC Commands"
• ":SBUS<n>:LIN Commands"
• ":SBUS<n>:M1553 Commands"
• ":SBUS<n>:SPI Commands"
• ":SBUS<n>:UART Commands"
Introduction to
The :SBUS subsystem commands control the serial decode bus viewing,
:SBUS<n> mode, and other options.
Commands
These commands are only valid on oscilloscope models when a serial decode option has
N O T E
been licensed.
The following serial bus decode/trigger types are available (see
":TRIGger:MODE"
• CAN (Controller Area Network) triggering— will trigger on CAN
version 2.0A and 2.0B signals. Setup consists of connecting the
oscilloscope to a CAN signal. Baud rate, signal source, and signal
polarity, and type of data to trigger on can be specified. You can trigger
on CAN data and identifier patterns and you can set the bit sample
point.
• I2S (Inter- IC Sound or Integrated Interchip Sound bus) triggering—
consists of connecting the oscilloscope to the serial clock, word select,
and serial data lines, then triggering on a data value.
Agilent InfiniiVision 3000 X-Series Oscilloscopes
Programmer's Guide
26
:SBUS<n> Commands
on page 600
on page 618
on page 654
on page 673
on page 683
on page 697
on page 704
on page 721
on page 851).
s1
on page 595
on page 597
on page 635
595