Power:harmonics:apply - Agilent Technologies InfiniiVision 3000 Programmer's Manual

23
:POWer Commands

:POWer:HARMonics:APPLy

Command Syntax
:POWer:HARMonics:APPLy
The :POWer:HARMonics:APPLy command applies the current harmonics
analysis.
Switching power supplies draw a range of harmonics from the AC mains.
Standard limits are set for these harmonics because these harmonics can
travel back to the supply grid and cause problems with other devices on
the grid.
Use the Current Harmonics analysis to test a switching power supply's
current harmonics to pre- compliance standard of IEC61000- 3- 2 (Class A,
B, C, or D). The analysis presents up to 40 harmonics.
See Also
•
•
•
•
•
•
•
•
•
514
(see page 1088)
":POWer:HARMonics:DATA"
":POWer:HARMonics:DISPlay"
":POWer:HARMonics:FAILcount"
":POWer:HARMonics:LINE"
":POWer:HARMonics:POWerfactor"
":POWer:HARMonics:STANdard"
":POWer:HARMonics:STATus"
":POWer:HARMonics:RUNCount"
":POWer:HARMonics:THD"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 515
on page 516
on page 517
on page 518
on page 519
on page 521
on page 522
on page 520
on page 523