Agilent Technologies InfiniiVision 3000 Programmer's Manual page 400

19
:MEASure Commands
Vtop. If you want to move the delay measurement point nearer to Vtop or
Vbase, you must change the threshold values with the :MEASure:DEFine
THResholds command.
Return Format
<value><NL>
<value> ::= floating-point number delay time in seconds in NR3 format
See Also •
•
•
400
"Introduction to :MEASure Commands"
":MEASure:DEFine" on page 396
":MEASure:PHASe" on page 411
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 388