Sbus<N>:Spi:framing - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:SBUS<n>:SPI:FRAMing
Command Syntax
:SBUS<n>:SPI:FRAMing <value>
<value> ::= {CHIPselect | {NCHipselect | NOTC} | TIMeout}
The :SBUS<n>:SPI:FRAMing command sets the SPI trigger framing value. If
TIMeout is selected, the timeout value is set by the
:SBUS<n>:SPI:CLOCk:TIMeout command.
The NOTC value is deprecated. It is the same as NCHipselect.
N O T E
Query Syntax
:SBUS<n>:SPI:FRAMing?
The :SBUS<n>:SPI:FRAMing? query returns the current SPI framing value.
Return Format
<value><NL>
<value> ::= {CHIP | NCH | TIM}
See Also
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 851
":SBUS<n>:SPI:CLOCk:TIMeout"
":SBUS<n>:SPI:SOURce:FRAMe"
:SBUS<n> Commands
on page 843
on page 708
on page 712
26
709