Power:signals:source:voltage<I - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:POWer:SIGNals:SOURce:VOLTage<i>
Command Syntax
:POWer:SIGNals:SOURce:VOLTage<i> <source>
<i> ::= 1, 2 in NR1 format
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
The :POWer:SIGNals:SOURce:VOLTage<i> command specifies the first, and
perhaps second, voltage source channel to be used in the power analysis.
Query Syntax
:POWer:SIGNals:SOURce:VOLTage<i>?
The :POWer:SIGNals:SOURce:VOLTage<i> query returns the voltage source
channel setting.
Return Format
<source><NL>
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
See Also
•
•
•
•
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
":POWer:SIGNals:AUTosetup"
":POWer:SIGNals:CYCLes"
":POWer:SIGNals:DURation"
":POWer:SIGNals:IEXPected"
":POWer:SIGNals:OVERshoot"
":POWer:SIGNals:VMAXimum"
":POWer:SIGNals:VSTeady"
":POWer:SIGNals:SOURce:CURRent<i>"
on page 541
on page 542
on page 543
on page 544
on page 545
on page 546
on page 547
on page 548
23
:POWer Commands
549