Power:signals:overshoot - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:POWer:SIGNals:OVERshoot

Command Syntax
:POWer:SIGNals:OVERshoot <percent>
<percent> ::= percent of overshoot value in NR1 format
The :POWer:SIGNals:OVERshoot command specifies the percent of
overshoot of the output voltage. This value is used to determine the
settling band value for the transient response and to adjust the vertical
scale of the oscilloscope.
Query Syntax
:POWer:SIGNals:OVERshoot?
The :POWer:SIGNals:OVERshoot query returns the overshoot percent
setting.
Return Format
<percent><NL>
<percent> ::= percent of overshoot value in NR1 format
See Also •
•
•
•
•
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
":POWer:TRANsient:APPLy"
":POWer:SIGNals:AUTosetup"
":POWer:SIGNals:CYCLes"
":POWer:SIGNals:DURation"
":POWer:SIGNals:IEXPected"
":POWer:SIGNals:VMAXimum"
":POWer:SIGNals:VSTeady"
":POWer:SIGNals:SOURce:CURRent<i>"
":POWer:SIGNals:SOURce:VOLTage<i>"
on page 559
on page 541
on page 542
on page 543
on page 544
on page 546
on page 547
on page 548
on page 549
23
:POWer Commands
545