Sbus<N>:Flexray:trigger:frame:id - Agilent Technologies InfiniiVision 3000 Programmer's Manual

26
:SBUS<n> Commands
:SBUS<n>:FLEXray:TRIGger:FRAMe:ID
Command Syntax
:SBUS<n>:FLEXray:TRIGger:FRAMe:ID <frame_id>
<frame_id> ::= {ALL | <frame #>}
<frame #> ::= integer from 1-2047
The :SBUS<n>:FLEXray:TRIGger:FRAMe:ID command sets the FlexRay
frame ID to trigger on. The frame ID setting is only valid when the
FlexRay trigger mode is set to FRAMe.
Query Syntax
:SBUS<n>:FLEXray:TRIGger:FRAMe:ID?
The :SBUS<n>:FLEXray:TRIGger:FRAMe:ID? query returns the current
frame ID setting for the FlexRay frame trigger setup.
Return Format
<frame_id><NL>
<frame_id> ::= {ALL | <frame #>}
<frame #> ::= integer from 1-2047
See Also
•
•
•
652
(see page 1088)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 851
":SBUS<n>:FLEXray:TRIGger"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 843
on page 645