Search:serial:lin:pattern:data - Agilent Technologies InfiniiVision 3000 Programmer's Manual

27
:SEARch Commands

:SEARch:SERial:LIN:PATTern:DATA

Command Syntax
:SEARch:SERial:LIN:PATTern:DATA <string>
When :SEARch:SERial:LIN:PATTern:FORMat DECimal,
<string> ::= "n" where n ::= 32-bit integer in unsigned decimal
When :SEARch:SERial:LIN:PATTern:FORMat HEX,
<string> ::= "0xnn...n" where n ::= {0,..,9 | A,..,F | X }
The :SEARch:SERial:LIN:PATTern:DATA command specifies the data value
when searching for LIN events.
The number base of the value entered with this command is specified
using the :SEARch:SERial:LIN:PATTern:FORMat command. To set don't care
values with the DATA command, the FORMat must be HEX.
The length of the data value entered is specified using the
:SEARch:SERial:LIN:PATTern:DATA:LENGth command.
Query Syntax
:SEARch:SERial:LIN:PATTern:DATA?
The :SEARch:SERial:LIN:PATTern:DATA? query returns the current data
value setting.
Return Format
<string><NL>
When :SEARch:SERial:LIN:PATTern:FORMat DECimal,
<string> ::= "n" where n ::= 32-bit integer in unsigned decimal or
When :SEARch:SERial:LIN:PATTern:FORMat HEX,
<string> ::= "0xnn...n" where n ::= {0,..,9 | A,..,F | X }
See Also
•
•
•
•
802
(see page 1088)
"$" if data has any don't cares
Chapter 27, ":SEARch Commands," starting on page 743
":SEARch:SERial:LIN:MODE"
":SEARch:SERial:LIN:PATTern:FORMat"
":SEARch:SERial:LIN:PATTern:DATA:LENGth"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 801
on page 804
on page 803