Power:inrush:exit - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:POWer:INRush:EXIT

Command Syntax
:POWer:INRush:EXIT
The :POWer:INRush:EXIT command exits (stops) the inrush current power
analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope
front panel during the analysis.
See Also
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
":POWer:INRush:APPLy"
":POWer:INRush:NEXT"
on page 524
on page 526
23
:POWer Commands
525