Sbus<N>:Iic:trigger:pattern:data2 - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:SBUS<n>:IIC:TRIGger:PATTern:DATa2
Command Syntax
:SBUS<n>:IIC:TRIGger:PATTern:DATa2 <value>
<value> ::= integer or <string>
<string> ::= "0xnn" where n ::= {0,..,9 | A,..,F}
The :SBUS<n>:IIC:TRIGger:PATTern:DATa2 command sets IIC data 2. The
data value can range from 0x00 to 0x0FF (hexadecimal). Use the don't
care data pattern (- 1 or 0xFFFFFFFF) to ignore the data value.
Query Syntax
:SBUS<n>:IIC:TRIGger:PATTern:DATa2?
The :SBUS<n>:IIC:TRIGger:PATTern:DATa2? query returns the current
pattern for IIC data 2.
Return Format
<value><NL>
See Also •
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
"Introduction to :TRIGger Commands"
":SBUS<n>:IIC:TRIGger:PATTern:ADDRess"
":SBUS<n>:IIC:TRIGger:PATTern:DATA"
":SBUS<n>:IIC:TRIGger[:TYPE]"
:SBUS<n> Commands
on page 843
on page 677
on page 678
on page 681
26
679