Sbus<N>:I2S:alignment - Agilent Technologies InfiniiVision 3000 Programmer's Manual

26
:SBUS<n> Commands
:SBUS<n>:I2S:ALIGnment
Command Syntax
:SBUS<n>:I2S:ALIGnment <setting>
<setting> ::= {I2S | LJ | RJ}
The :SBUS<n>:I2S:ALIGnment command selects the data alignment of the
I2S bus for the serial decoder and/or trigger when in I2S mode:
• I2S — standard.
• LJ — left justified.
• RJ — right justified.
Note that the word select (WS) polarity is specified separately with the
:SBUS<n>:I2S:WSLow command.
Query Syntax
:SBUS<n>:I2S:ALIGnment?
The :SBUS<n>:I2S:ALIGnment? query returns the currently selected I2S
data alignment.
Return Format
<setting><NL>
<setting> ::= {I2S | LJ | RJ}
See Also •
•
•
•
•
656
(see page 1088)
"Introduction to :TRIGger Commands"
":SBUS<n>:I2S:CLOCk:SLOPe"
":SBUS<n>:I2S:RWIDth"
":SBUS<n>:I2S:TWIDth"
":SBUS<n>:I2S:WSLow"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 843
on page 658
on page 659
on page 671
on page 672