Sbus<N>:Spi:trigger:pattern:mosi:data - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA
Command Syntax
:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA <string>
<string> ::= "nn...n" where n ::= {0 | 1 | X | $}
<string ::= "0xnn...n" where n ::= {0,..,9 | A,..,F | X | $}
The :SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA command defines the SPI
data pattern resource according to the string parameter. This pattern,
along with the data width, control the data pattern searched for in the
data stream.
If the string parameter starts with "0x", it is a hexadecimal string made up
of hexadecimal and X (don't care) characters; otherwise, it is a binary
string made up of 0, 1, and X (don't care) characters.
The :SBUS<n>:SPI:TRIGger:PATTern:MOSI:WIDTh should be set before
N O T E
:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA.
Query Syntax
:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA?
The :SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA? query returns the current
settings of the specified SPI data pattern resource in the binary string
format.
Return Format
<string><NL>
See Also •
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
"Introduction to :TRIGger Commands"
":SBUS<n>:SPI:TRIGger:PATTern:MOSI:WIDTh"
":SBUS<n>:SPI:SOURce:MOSI"
":SBUS<n>:SPI:SOURce:DATA"
on page 843
on page 718
on page 714
on page 711
26
:SBUS<n> Commands
717