:TRIGger:DELay:ARM:SLOPe
Command Syntax
:TRIGger:DELay:ARM:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:DELay:ARM:SLOPe command specifies rising (POSitive) or
falling (NEGative) for the arming edge in the Edge Then Edge triggger.
Query Syntax
:TRIGger:DELay:ARM:SLOPe?
The :TRIGger:DELay:ARM:SLOPe? query returns the current arming edge
slope setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see
page
1088)
"Introduction to :TRIGger Commands"
":TRIGger:DELay:ARM:SOURce"
":TRIGger:DELay:TDELay:TIME"
on page 843
on page 856
on page 857
30
:TRIGger Commands
855