Trigger:usb:speed - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:TRIGger:USB:SPEed

Command Syntax
:TRIGger:USB:SPEed <value>
<value> ::= {LOW | FULL}
The :TRIGger:USB:SPEed command sets the expected USB signal speed to
be Low Speed (1.5 Mb/s) or Full Speed (12 Mb/s).
Query Syntax
:TRIGger:USB:SPEed?
The :TRIGger:USB:SPEed? query returns the current speed value for the
USB signal.
Return Format
<value><NL>
See Also
•
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 851
":TRIGger:USB:SOURce:DMINus"
":TRIGger:USB:SOURce:DPLus"
":TRIGger:USB:TRIGger"
on page 843
on page 919
on page 920
on page 922
30
:TRIGger Commands
921