Agilent Technologies InfiniiVision 3000 Programmer's Manual page 998

34
Obsolete and Discontinued Commands
Obsolete Command
:PRINt? (see
:SAVE:IMAGe:AREA (see
page
:TIMebase:DELay (see
page
:SBUS<n>:LIN:SIGNal:DEFiniti
on (see
:TRIGger:THReshold (see
page
:TRIGger:TV:TVMode (see
page
Discontinued
Discontinued commands are commands that were used by previous
Commands
oscilloscopes, but are not supported by the InfiniiVision 3000 X- Series
oscilloscopes. Listed below are the Discontinued commands and the
nearest equivalent command available (if any).
Discontinued Command
ASTore
CHANnel:MATH
CHANnel<n>:PROTect
DISPlay:INVerse
DISPlay:COLumn
DISPlay:FREeze
DISPlay:GRID
DISPLay:LINE
998
page 1039)
1041)
1043)
page 1042)
1044)
1045)
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
Current Command Equivalent
:DISPlay:DATA? (see
page 296)
none
:TIMebase:POSition (see
page 834) or
:TIMebase:WINDow:POSition
(see page 839)
none
:POD<n>:THReshold (see
page 505) or
:DIGital<d>:THReshold (see
page 287)
:TRIGger:TV:MODE (see
page 910)
Current Command Equivalent
:DISPlay:PERSistence INFinite
(see page 299)
:FUNCtion:OPERation (see
page 331)
:CHANnel<n>:PROTection
(see page 268)
none
none
none
none
none
Behavior Differences
TIMebase:POSition is position
value of main time base;
TIMebase:WINDow:POSition
is position value of zoomed
(delayed) time base window.
Comments
ADD not included
Previous form of this
command was used to
enable/disable 50Ω
protection. The new command
resets a tripped protect and
the query returns the status of
TRIPed or NORMal.