Search:serial:can:pattern:id:mode - Agilent Technologies InfiniiVision 3000 Programmer's Manual

X-series
Hide thumbs Also See for InfiniiVision 3000:
Table of Contents

Advertisement

:SEARch:SERial:CAN:PATTern:ID:MODE

Command Syntax
:SEARch:SERial:CAN:PATTern:ID:MODE <value>
<value> ::= {STANdard | EXTended}
The :SEARch:SERial:CAN:PATTern:ID:MODE command specifies whether a
standard ID value or an extended ID value is used when searching for a
CAN event.
The ID value is specified using the :SEARch:SERial:CAN:PATTern:ID
command.
Query Syntax
:SEARch:SERial:CAN:PATTern:ID:MODE?
The :SEARch:SERial:CAN:PATTern:ID:MODE? query returns the current
setting.
Return Format
<value><NL>
<value> ::= {STAN | EXT}
See Also
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see
page
1088)
Chapter
27, ":SEARch Commands," starting on page 743
":SEARch:SERial:CAN:MODE"
":SEARch:SERial:CAN:PATTern:ID"
on page 775
on page 778
27
:SEARch Commands
779

Advertisement

Table of Contents
loading

Table of Contents