Agilent Technologies InfiniiVision 3000 Programmer's Manual page 630

26
:SBUS<n> Commands
CAN Id specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:ID
and:SBUS<n>:CAN:TRIGger:PATTern:ID:MODE commands.
CAN Data specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:DATA
command.
CAN Data Length Code is set by the
:SBUS<n>:CAN:TRIGger:PATTern:DATA:LENGth command.
Query Syntax
:SBUS<n>:CAN:TRIGger?
The :SBUS<n>:CAN:TRIGger? query returns the current CAN trigger on
condition.
Return Format
<condition><NL>
<condition> ::= {SOF | DATA | ERR | IDD | IDE | IDR | ALL | OVER | ACK}
Errors
•
See Also
•
•
•
•
•
•
•
•
630
"- 241, Hardware missing"
"Introduction to :SBUS<n> Commands"
":SBUS<n>:MODE" on page 599
":SBUS<n>:CAN:TRIGger:PATTern:DATA"
":SBUS<n>:CAN:TRIGger:PATTern:DATA:LENGth"
":SBUS<n>:CAN:TRIGger:PATTern:ID"
":SBUS<n>:CAN:TRIGger:PATTern:ID:MODE"
":SBUS<n>:CAN:SIGNal:DEFinition"
":SBUS<n>:CAN:SOURce"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 1049
on page 595
on page 631
on page 633
on page 634
on page 627
on page 628
on page 632