Power:signals:duration - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:POWer:SIGNals:DURation

Command Syntax
:POWer:SIGNals:DURation <value>[suffix]
<value> ::= value in NR3 format
[suffix] ::= {s | ms | us | ns}
The :POWer:SIGNals:DURation command specifies the duration of the
power analysis
This command is available in certain types of power analysis only, for
example, Efficiency, Modulation, Transient Response, Turn On/Off Time,
and Output Ripple.
Query Syntax
:POWer:SIGNals:DURation?
The :POWer:SIGNals:DURation query returns the set duration time value.
Return Format
<value><NL>
<value> ::= value in NR3 format
See Also
•
•
•
•
•
•
•
•
•
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
":POWer:EFFiciency:APPLy"
":POWer:MODulation:APPLy"
":POWer:ONOFf:APPLy"
":POWer:TRANsient:APPLy"
":POWer:RIPPle:APPLy"
":POWer:SIGNals:AUTosetup"
":POWer:SIGNals:CYCLes"
":POWer:SIGNals:IEXPected"
":POWer:SIGNals:OVERshoot"
":POWer:SIGNals:VMAXimum"
":POWer:SIGNals:VSTeady"
":POWer:SIGNals:SOURce:CURRent<i>"
":POWer:SIGNals:SOURce:VOLTage<i>"
on page 512
on page 527
on page 530
on page 559
on page 540
on page 541
on page 542
on page 544
on page 545
on page 546
on page 547
on page 548
on page 549
23
:POWer Commands
543