Power:signals:vsteady - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:POWer:SIGNals:VSTeady

Command Syntax
:POWer:SIGNals:VSTeady <value>[suffix]
<value> ::= Expected steady state output Voltage value in NR3 format
[suffix] ::= {V | mV}
The :POWer:SIGNals:VSTeady command specifies the expected steady state
output DC voltage of the power supply.
This value is used along with the overshoot percentage to specify the
settling band for the transient response and to adjust the vertical scale of
the oscilloscope.
Query Syntax
:POWer:SIGNals:VSTeady?
The :POWer:SIGNals:VSTeady query returns the expected steady state
voltage setting.
Return Format
<value><NL>
<value> ::= Expected steady state output Voltage value in NR3 format
See Also •
•
•
•
•
•
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
":POWer:ONOFf:APPLy"
":POWer:TRANsient:APPLy"
":POWer:SIGNals:AUTosetup"
":POWer:SIGNals:CYCLes"
":POWer:SIGNals:DURation"
":POWer:SIGNals:IEXPected"
":POWer:SIGNals:OVERshoot"
":POWer:SIGNals:VMAXimum"
":POWer:SIGNals:SOURce:CURRent<i>"
":POWer:SIGNals:SOURce:VOLTage<i>"
on page 530
on page 559
on page 541
on page 542
on page 543
on page 544
on page 545
on page 546
on page 548
on page 549
23
:POWer Commands
547