Sbus<N>:Mode - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:SBUS<n>:MODE
Command Syntax
:SBUS<n>:MODE <mode>
<mode> ::= {A429 | FLEXray | CAN | I2S | IIC | LIN | M1553 | SPI | UART}
The :SBUS<n>:MODE command determines the decode mode for the serial
bus.
This command is only valid when a serial decode option has been licensed.
N O T E
Query Syntax
:SBUS<n>:MODE?
The :SBUS<n>:MODE? query returns the current serial bus decode mode
setting.
Return Format
<mode><NL>
<mode> ::= {A429 | FLEX | CAN | I2S | IIC | LIN | M1553 | SPI | UART
Errors
•
See Also •
•
•
•
•
•
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
| NONE}
"- 241, Hardware missing"
"Introduction to :SBUS<n> Commands"
":SBUS<n>:A429 Commands"
":SBUS<n>:CAN Commands"
":SBUS<n>:FLEXray Commands"
":SBUS<n>:I2S Commands"
":SBUS<n>:IIC Commands"
":SBUS<n>:LIN Commands"
":SBUS<n>:M1553 Commands"
":SBUS<n>:SPI Commands"
":SBUS<n>:UART Commands"
on page 1049
on page 595
on page 600
on page 618
on page 635
on page 654
on page 673
on page 683
on page 697
on page 704
on page 721
26
:SBUS<n> Commands
599