Search:serial:uart:data - Agilent Technologies InfiniiVision 3000 Programmer's Manual

27
:SEARch Commands

:SEARch:SERial:UART:DATA

Command Syntax
:SEARch:SERial:UART:DATA <value>
<value> ::= 8-bit integer from 0-255 (0x00-0xff) in decimal,
<hexadecimal> ::= #Hnn where n ::= {0,..,9| A,..,F} for hexadecimal
<binary> ::= #Bnn...n where n ::= {0 | 1} for binary
<quoted_string> ::= any of the 128 valid 7-bit ASCII characters (or
The :SEARch:SERial:UART:DATA command specifies a data value when
searching for UART/RS232 events.
The data value qualifier is specified using the
:SEARch:SERial:UART:QUALifier command.
Query Syntax
:SEARch:SERial:UART:DATA?
The :SEARch:SERial:UART:DATA? query returns the current data value
setting.
Return Format
<value><NL>
<value> ::= 8-bit integer from 0-255 (0x00-0xff) in decimal format
See Also
•
•
•
814
(see page 1088)
<hexadecimal>, <binary>, or <quoted_string> format
standard abbreviations)
Chapter 27, ":SEARch Commands," starting on page 743
":SEARch:SERial:UART:MODE"
":SEARch:SERial:UART:QUALifier"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 815
on page 816