Agilent Technologies InfiniiVision 3000 Programmer's Manual page 832

29
:TIMebase Commands
Introduction to The TIMebase subsystem commands control the horizontal (X- axis)
:TIMebase
functions and set the oscilloscope to X- Y mode (where channel 1 becomes
Commands
the X input and channel 2 becomes the Y input). The time per division,
delay, vernier control, and reference can be controlled for the main and
window (zoomed) time bases.
Reporting the Setup
Use :TIMebase? to query setup information for the TIMebase subsystem.
Return Format
The following is a sample response from the :TIMebase? query. In this
case, the query was issued following a *RST command.
:TIM:MODE MAIN;REF CENT;MAIN:RANG +1.00E-03;POS +0.0E+00
832 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide