Measure:pedges - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:MEASure:PEDGes

Command Syntax
:MEASure:PEDGes [<source>]
<source> ::= {CHANnel<n> | FUNCtion | MATH | WMEMory<r>}
<n> ::= 1 to (# analog channels) in NR1 format
<r> ::= 1-2 in NR1 format
The :MEASure:PEDGes command installs a rising edge count measurement
on screen. If the optional source parameter is not specified, the current
source is measured.
This command is not available if the source is FFT (Fast Fourier Transform).
N O T E
Query Syntax
:MEASure:PEDGes? [<source>]
The :MEASure:NEDGes? query measures and returns the on- screen rising
edge count.
Return Format
<value><NL>
<value> ::= the rising edge count in NR3 format
See Also
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
"Introduction to :MEASure Commands"
":MEASure:SOURce"
on page 388
on page 421
19
:MEASure Commands
409