Sbus<N>:Uart:parity - Agilent Technologies InfiniiVision 3000 Programmer's Manual

26
:SBUS<n> Commands
:SBUS<n>:UART:PARity
Command Syntax
:SBUS<n>:UART:PARity <parity>
<parity> ::= {EVEN | ODD | NONE}
The :SBUS<n>:UART:PARity command selects the parity to be used with
each message "byte" for the serial decoder and/or trigger when in UART
mode.
Query Syntax
:SBUS<n>:UART:PARity?
The :SBUS<n>:UART:PARity? query returns the current UART parity
setting.
Return Format
<parity><NL>
<parity> ::= {EVEN | ODD | NONE}
See Also
•
•
•
732
(see page 1088)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 851
":SBUS<n>:UART:TRIGger:TYPE"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 843
on page 741