Measure:bwidth - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:MEASure:BWIDth

Command Syntax
:MEASure:BWIDth [<source>]
<source> ::= {CHANnel<n> | FUNCtion | MATH | WMEMory<r>}
<n> ::= 1 to (# analog channels) in NR1 format
<r> ::= 1-2 in NR1 format
The :MEASure:BWIDth command installs a burst width measurement on
screen. If the optional source parameter is not specified, the current
measurement source is used.
This command is not available if the source is FFT (Fast Fourier Transform).
N O T E
Query Syntax
:MEASure:BWIDth? [<source>]
The :MEASure:BWIDth? query measures and returns the width of the burst
on the screen.
The burst width is calculated as follows:
Return Format
<value><NL>
<value> ::= burst width in seconds in NR3 format
See Also •
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
burst width = (last edge on screen - first edge on screen)
"Introduction to :MEASure Commands"
":MEASure:SOURce"
on page 388
on page 421
19
:MEASure Commands
393