Agilent Technologies InfiniiVision 3000 Programmer's Manual page 961

Table 137 :WGEN Commands Summary (continued)
Command
:WGEN:VOLTage:LOW
<low> (see page 983)
:WGEN:VOLTage:OFFSet
<offset> (see
page 984)
Introduction to
The :WGEN subsystem provides commands to select the waveform
:WGEN generator function and parameters.
Commands
Reporting the Setup
Use :WGEN? to query setup information for the WGEN subsystem.
Return Format
The following is a sample response from the :WGEN? query. In this case,
the query was issued following the *RST command.
:WGEN:FUNC SIN;OUTP 0;FREQ +1.0000E+03;VOLT +500.0E-03;VOLT:OFFS
+0.0E+00;:WGEN:OUTP:LOAD ONEM
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
Query
:WGEN:VOLTage:LOW?
(see page 983)
:WGEN:VOLTage:OFFSet?
(see page 984)
Options and Query Returns
<low> ::= low-level voltage in
volts, in NR3 format
<offset> ::= offset in volts in
NR3 format
32
:WGEN Commands
961