Trigger:sweep - Agilent Technologies InfiniiVision 3000 Programmer's Manual

Hide thumbs Also See for InfiniiVision 3000:

Table of Contents

:TRIGger Commands

:TRIGger:SWEep

Command Syntax

:TRIGger:SWEep <sweep>

<sweep> ::= {AUTO | NORMal}

The :TRIGger:SWEep command selects the trigger sweep mode.

When AUTO sweep mode is selected, a baseline is displayed in the absence

of a signal. If a signal is present but the oscilloscope is not triggered, the

unsynchronized signal is displayed instead of a baseline.

When NORMal sweep mode is selected and no trigger is present, the

instrument does not sweep, and the data acquired on the previous trigger

remains on the screen.

This feature is called "Mode" on the instrument's front panel.

Query Syntax

:TRIGger:SWEep?

The :TRIGger:SWEep? query returns the current trigger sweep mode.

Return Format

<sweep> ::= current trigger sweep mode